Daily, Weekly, Monthly Belt Conveyor Check&Maintenance Work

When using the belt conveyor, less daily check and maintenance or do not pay attention to maintenance will greatly reduce the service life of the belt conveyor, when the belt conveyor problems occur, it will affect the work efficiency, so regular inspection for belt conveyor parts is needed.
Daily check
Mechanical items: inspect the guardrail, bridge, roller, pulley, turnabout pulley and belt.
Electrical items: inspect the anti-skid device, deviation switch, emergency stop switch, tear detection device, anti-reverse device.

Weekly check
Mechanical items: inspect the driving wheel, guide wheel section, reducer, inspect the machine's tail, check tensioning device and pull rope device.
Electrical items: inspect the main motor, inverter, filter, repair and inspect the main transformer wiring, electrical control, power system.
Monthly check
Mechanical items: inspect the rope wheel, transition wheel, guide wheel, driving wheel, belt wheel, tensioning car and check the oiling.
Electrical items: inspect the fastening bolts, fast switch; the maintenance and repair of commutator, limit protection, emergency stop protection and the alarm system. 

 

Follow the Right Operation of Fixed Belt Conveyor, Otherwise Accident will Occur

1.Fixed belt conveyor should be fixed in accordance with the specified installation methods on the foundation;
2.Before start-up ,please check all the moving parts of belt conveyor, such as if belt buckles and bearing device is normal, if the protective device is complete, if the belt tensioning condition is adjusted properly before start-up;
3. Fixed belt conveyor should no-load start up, only when operation is normal, can you feed the material, feed material before starting up the conveyor is not allowed;
4. when units of belt conveyor operate in series, please start from the discharged end in order, only when the operation is normal ,can you feed the material;

 

5. When belt deviation appeared in the operation of the belt conveyor, please stop the conveyor and adjust timely, so as not to wear edges and increase the load;
6. The work environment and material temperature should not be higher than 50℃ and lower than -10 ℃;
7. The conveyor must not convey people, and people is not allowed to stand under the conveyor;
8. Stop feeding material before stopping the conveyor, only after stored materials are discharged completely you can stop the conveyor;
9. Belt conveyor motor must be in good insulation;
10.Do not use your hand to pull the belt in order to avoid accidents when belt slips.