Belt Conveyor

The main cause of conveyor belt skid is that the friction between conveyor belt and pulley is not enough, details please see the following three aspects:

1.The running resistance is increased, such as conveyor overloads, conveyor belt is squeezed and stuck on the frame, roller damages, stuff twines, material buries etc. will cause lots of rollers can not rotate well.
Solution: conveyor overload is strictly prohibited, the conveying capacity must be designed within the theoretical range ; Replace the roller which can not rotate flexibly; Fully check the entire transportation process, eliminate the bad affecting factors.

2.The friction coefficient is reduced, for example, the contact area of driving drum and belt enters into water, sundry. Rubber coated surface of driving pulley damages.
Solution: replace the driving pulley and clean the stuff that on the non-working conveyor belt surface.

3.The conveyor belt tension is reduced, for example, if the conveyor belt overload works for a long time, the belt will be deformed and stretched, besides, the tension of take-up device is not enough which will leads the tensile force decreases.
Solution: increase the tensioning stroke according to the working conditions, you can also cut off a piece of conveyor belt to solve the problem when the tension is not enough.